Information on page 4 Table 1 Basic Operating Table is at the top, with a 2-paragraph caption. The bottom begins 1. Monostable Operation and has 3 figures. Figure 1 is a circuit diagram. Discharge 7 is wired to threshold 8 with a resistor to VCc and a capacitor to ground. Cont 5 has a capacitor to ground. 2 Trigger is wired to a user source, as is 3 out to a user load. Figure 2 shows R and C vs time. All lines are directly proportional to time, at 45 degrees. It looks like C(t) = 0 moves to higher t values as the resistance increases, crossing t=0 at R= 10kOhm I think. Figure 3 shows the waveforms of trigger, output, and threshold for monostable operation, under R=9.1kOhm, load=1kOhm, C to thresh=0.01uF, VCC=5v Output is a square wave. Thresh is a shark tooth while output=1, 0 when output=0. Trigger is mostly high, 0 briefly at the start of the shark tooth.